![]() ![]() ![]() ![]() ![]() Heard a bit of slowing down closer to the end and the nuts around the nylon bolt were quite hot. The foam is still attached, thus tabs are not needed, but separates easily. But at 65 (22% throttle, hard to say what RPM it was, probably under 6000) it looked reasonable. Made a second attempt, this time instead of setting RPM (probably around 10000, was setting the servo to 80, with usable range between 45 and 135 gives about 40% throttle) and varying feed rate, I set the feed rate and tried to find the lowest usable RPM.Īt servo setting 60 (giving 17% throttle, probably around 4600rpm from the previous propeller measurements) the foam was too attached, even after 2 passes.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |